Average Reviews:
(More customer reviews)I got this awhile back ago, and it was very simple to put on and didn't cost a lot.My car got on the dyno before and after installing the Skunk2 intake manifold, and also the 66mm throttle body too.After three runs, I saw good results.The horsepower only got about 12whp or so on average (about what is advertised), and surprisingly got somewhere in the mid-30's lb-torque.Granted, the car is boosted, so these increases are typically greater than the naturally aspirated.
I am very satisfied with the results, and would recommend this to anyone.I do notice the increased power and hope to see bigger increase after a professional tune.This product is considered to be not street legal, but I doubt any law enforcers will go to check to and see.
Click Here to see more reviews about: Skunk2 307-05-0300 Racing Intake Manifolds
Product Description:
(H22A1/H22A2 (Will not work with SH)) Built for the (94-01) Honda Prelude... The most restrictive part of any induction system is the factory intake manifold.Knowing this, Skunk2 Racing went to great lengths to design and manufacture an appropriate aftermarket replacement.Skunk2 Racing manifolds are designed to maximize flow as well as increase the effects of wave scavenging at each engine's key operating RPM range.Each manifold is designed to use all the stock sensors and auxiliaries.Some key features:-Single-stage intake manifold design-Significant mid to high range power gains-CARB EO-pending-Factory throttle body may be reused-Utilizes all factory sensors-Larger plenum and runners to optimize horsepowerVQ35 Notes: 350z and G35 5/8" spacer will not fit 06' vehicles. Also will not fit 350z's with Rev-Up engines (ie 05' TRACK model or Anniversary Edition)
Get 9% OFF
Want to read more honest consumer review about Skunk2 307-05-0300 Racing Intake Manifolds now ?
No comments:
Post a Comment